Turning Data into Knowledge

CognIoT™ is a trademark of
Bostin Technology Services Ltd.

Copyright © 2017 by BostinTechnology Services Ltd  ·  All Rights reserved  ·  Sales@BostinTechnology.com
NFC RFID Reader for Raspberry Pi
CognIoT™ continues the theme of offering a great OOB (out of box) experiences for Pi based RFID readers. Just plug the NFC reader into your Pi and it will be reading tags even before you have run any software on the Pi. Add software (example code provided) to turn your Pi into a powerful NFC reader and interact with tags or NFC enabled phones.
The NFC Reader supports all of the common NFC standards based on ISO14443A. The standards are often referred to as NFC type 2, MIFARE Classic® MIFARE Ultralight®, MIFARE DESFire® or NTAG2.

Communication is via the Pi's UART so not even a low level driver is required to get the Reader up and running. The Reader provides a powerful command structure through the Pi’s UART allowing the Pi full control of its extensive capabilities.

Key Features
• Great OOB (out-of-box) experience
o Reader works without the need for low level drivers to be downloaded and compiled.
• Complete read and write solution for the most widely used NFC cards and tags
o MIFARE Classic® 1k card (MF1 IC S50 transponder) and equivalents.
o MIFARE Classic® 4k card (MF1 IC S70 transponder)
o MIFARE Ultralight® card (MF0 IC U1 transponder)
o NTAG2 family of cards and tags
o MIFARE ProX, Smart MX (JCOP) dual-interface card types are supported to allow single or double UID to be acquired and “MIFARE” operations performed across the contactless interface.  MIFARE DESFire®, MIFARE Plus® supported for serial number acquisition.
• Data transfer at 106KBaud. Typical read/modify/write operating in about 100ms.
• Range of up to 8cm
• Simple interface controlled via the Raspberry Pi’s UART.
• LED indicates tag read. Optional Beep signal available to provide audible feedback of a read/write.
• 5VDC operation

Sample Commands
• Read UID
• Card Status
• Read/Write blocks
• Type Identification