Instructions describing how to install the 125KHz Reader Software

SW_125KHz_Installation_Instructions

One thought on “SW_125KHz_Installation_Instructions

  • October 11, 2018 at 12:10 pm
    Permalink

    Hello,
    I got a PirFLx1.1 RFID 125KHz reader that has no GPIO jumpers. I need the pin assignment of the 26 pin J1 because the Raspi has a 40 pin plug.
    In addition, the above-mentioned page http://www.cogniot.eu/DS_PirFlx.pdf is unknown.
    many Greetings
    Volker

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *